APG® GR03HFF31S - 1-Pc Chrome Polished 8x6 mm Horizontal Billet Main Grille

Installing this was hassle-free and the screws worked like a sheetrock mount. Took me 10 minutes to get it lined up and installed

2022 Ram 1500 Bighorn. Went on well, took me about 2 hrs total to put on. Involves removing alot of screws. I would recommend purchasing the speed clips for the radiator cover cause i broke like 2. Other than that looks really good!

Finally found a grill to fit my truck. Install was a bit tricky. Had to get creative with a magnet to hold the back pieces in place while starting the thread of the screw. Couldn’t get 2 of the screws installed on the upper piece due to lack of space for the back bracket. Kind of a funky design, but all in all took me about 30 minutes to install the 3 pieces. When purchasing, make sure to select the lower number piece. Would need to remove the licenses plate to install. Wish the was something available for the hood vent. No options available, yet.

Looks great when complete. Have to cut up the existing grille on the truck to make it fit/look good, but not very hard to do. Hardest part of install was taking the front end apart to remove the 3 bottom bolts that hole the grille on the truck.

Unique style from other Equinox on the road

Easy installation and looks awesome in my opinion.

Easy Installation.

Put this on my 2001 Ford Ranger Edge non XLT. It looks so sweet with new headlights! Four stars because it doesn't quite fit without a lot of work. The instructions were garbage, perhaps this is not an "open top" whatever that means. My Ranger has 3 plastic covers that cover the top of this and one each for the headlights. Took about 3 hours, since I had to relocate it once (lower). Job will go much faster without the headlights in place, since you'll be taking the old grill cover off a few times to get it fitted. The grill housing had it's old grill tabs cutoff so the new grill will sit flat against it. If not, there will be a gap between the new grill and the grill housing. The radiator shroud, soft plastic, is easy to cut with a box cutter for the top flanges of the new grill to lay in. The two lower flanges will need to be offset by about 1/2" to 5/8", somewhere in between. You can see the standoffs in the picture. The top four flanges of the new grill had to narrowed to fit into the slot, but only enough to be tight. You cannot bolt the top in, it just sits there, but not sloppy. I would give this a 5 star, but this is a lot of work, again, probably not made for this vehicle. The material is stainless steel, which is a better bang for the buck than aluminum. Was worth it for me!

This billet grill is nice but is not built to cover fog lights, the information says fits all models but sadly it doesn't. The quality seems decent and looks great!

Does not fit correctly and new holes have to be drilled into your bumper. Finish is satin and doesn't flow with a car that is gloss finish. It's sitting in my garage and won't be going on my crossfire.