General Technologies® - Oxygen Sensor Tester Simulator

Universal Oxygen Sensor Tester Simulator by General Technologies®. This high-tech, user friendly Oxygen Sensor Tester/Simulator model from General Technologies Corp/Sheffield Research sports a simple interface to perform diagnostic tests and measurements on any Oxygen Sensor and to quickly determine whether or not an Oxygen Sensor is actually defective and in need of replacement. It is designed to be used both, as a stand alone tool or as a compliment to any scanner during the diagnostic process. Can be used on: Zirconium Sensors. Titanium 1 volt sensors. Titanium 5 volt Sensors. Wide Band "dual-Cell" Sensors. Heated or unheated Sensors (1,2,3,4 or 5 wires). Diagnose "Lazy" sensors which may not trigger DTC's but cause driveability problems. Sensors can be tested either ON or OFF vehicles. Does not require special time-consuming set-up or in-depth knowledge. Real time cross count displayed on live bargraph. Instant PASS/FAIL results displayed on large alpha-numeric display.

Specifications

Includes

• ST05(Core unit)
• Two piercing clips with 6 ft. cables
• Protective rubber holster
• Polypropylene carrying case
• 1 x 9 Volt alkaline battery
• User’s Manual

Features

• The sensor signal output is shown in real time on the bar graph, while a 2 digit alphanumeric display shows the sensor output cross count per second
• By pressing the 'Test' button and performing a snap throttle acceleration of the engine, it tests the response time of the sensor and shows a pass or fail result within seconds.
• Two buttons allows for simulation of rich or lean conditions to monitor response of the engine control module
• Advanced connection detection: The ST05 automatically detects common wire misconnections like ground, heater wires, disconnected test leads, reversed polarity etc. and displays these on the alphanumeric display
• It only requires the connection of two probe clips to the oxygen sensor wires, and the selection of the oxygen sensor type

General Technologies® Corp entered the market with its first product, a cordless circuit tester, in 1988. Since that time General Technologies® has been working on expanding its product line to include other diagnostic and test equipment ranging from multimeters and tachometers to analyzers and tachometers. Nowadays it is recognized as an industry leader which introduced several innovative products such as the first handheld wireless digital instrument capable of measuring secondary ignition voltages in spark plug wires, the first short/open circuit tracer/detector and others.