Planet Audio® - Pulse Series 3000W Mono Class D Amplifier

0 reviews|Item # mpn4644767997|Similar Products
Universal Fit
  • Not Vehicle Specific
Authorized Dealer
$153.01
In Stock (10) - Ships in 24 to 48 hrs
Authorized Dealer
Have a Question? Ask a Specialist
888-903-4343Live Chat

Vehicle Fitment

This part is universal

Product Details

Pulse Series 3000W Mono Class D Amplifier by Planet Audio®. Boost that bass with this high-end amplifier from Planet Audio. Combining cutting-edge technology with a sleek design, this extremely powerful amp is a perfect tune-up for your car sound system. It has a MOSFET power supply feature which allows to provide high power with minimum distortion. This amp is sure to improve sound quality so your music will play loud and clear through your sound system.

Features

  • 1 Ohm Stable - The lowest impedance accepted by this amplifier is 1 Ohm. Amplifiers that are 1 Ohm stable produce the most power possible from the amp. An amplifier capable of delivering power at a 1 Ohm load is usually reserved for serious subwoofers that can handle the power
  • Class D Amps - Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps. Planet Audio use Class D in monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass
  • Protection - f the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself
  • Strapping Capability - Strapping capability means that two amplifiers can be linked together to create double the power at an impedance of 2 Ohms. A benefit of strapping is less electrical current is required than if you ran [2] individual amps at 1 Ohm and you only need 1 pair of preamp outputs and RCA cable to connect
  • Subsonic Filter - A subsonic filter is designed for use on subwoofers. Since not all subwoofers can reproduce the same low frequencies, the subsonic filter can be set for optimum bass response in order to keep the driver playing efficiently
  • Subwoofer Level Control - The ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output
  • Switchable Input Sensitivity - Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed
  • Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it
  • Variable Gain Control - Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping
  • Variable Low Pass Filter - Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.

Specifications:

General Specifications:

  • Amp Topology: Monoblock Class D
  • Channel Configuration: 1 Channel
  • Power Supply Type: MOSFET Power Supply

Performance Specifications:

  • Total Power Output: 3000W
  • Peak Power @ 1 Ohm: 3000W x 1
  • Peak Power @ 2 Ohm: 1500W x 1
  • RMS Power @ 4 Ohm: 563W x 1
  • Strapped Power bridged @ 2 Ohm: 6000W
  • Speaker Impedance: 1 to 8 Ohm
  • S/N Ratio (A-Weighted): 100 dB
  • Frequency Response: 15Hz to 250Hz ±1 dB

Connections, Controls, and Processing:

  • RCA Inputs: 2 Channel
  • Pre Amp Outputs: 2 Channel
  • Low Pass Filter: 50Hz to 250Hz
  • Subsonic Filter: 15Hz to 40Hz
  • Bass Boost: Variable 0 to 18 dB
  • Subwoofer Level Control: Yes
  • Input Sensitivity Switch: Yes
  • Strappable: Yes
  • Thermal/Overload/Short Protection: Yes

Measurement:

  • Length: 11.93"
  • Width: 7"
  • Height: 2.26"

Since 1996 Planet Audio® has become a World leader in mobile audio and video entertainment. The company's World headquarters is located in Oxnard, CA, along with its Research and Development division as well as manufacturing facilities in China, Brazil, Taiwan, California and Seoul, Korea. Today, even in the midst of rapidly advancing in-vehicle technology, their audio and video components incorporate flawlessly into today’s ever expanding new life styles and vehicles alike. Planet Audio is a seasoned manufacturer of mobile entertainment and information systems with a focus on performance and integration.

Part Number:
PL3000.1D
UPC:
636210105732
Alternate MPN:
PL30001D

Reviews

(0)
Only authorized customers can leave a review on our website. We would love to know what you like or dislike about the product. Share your opinion on product quality, appearance, installation, and other characteristics.
Planet Audio® - Pulse Series 3000W Mono Class D Amplifier
/0

Questions and Answers

(0)
If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!